PEEK over-molding plastic injection molding parts by Horizontal injection?
2022/10/26 427

The basic requirements of the product are as follows:


Product name:PEEK over-molding plastic injection molding parts

Product material: PEEK

Material Model: 330GL30H

The net weight of the product: 0.758g*2

Feed weight: 1.497g

Estimated weight: 2kg

Machine: Model Vertical Machine


Customer requirements:

1. For the PEEK over-molding plastic injection molding parts, a vertical machine sample is required! Temporarily use a horizontal machine

2.

 PEEK over-molding plastic injection molding parts design.jpg

3. There is a cylinder under the mold row, check whether the mold has a reset switch, and a reset switch should be installed to prevent the cylinder from not returning the mold!

4. 

PEEK over-molding plastic injection molding parts change demand.jpg

Solution for PEEK over-molding plastic injection molding parts:

1. The cylinder pushes the hardware to eject

2. The product is demolded (the red surface is reduced by glue according to the 2D tolerance requirements)

3. It is recommended to make a 0.1MM bulge for the rib part at the red circle (3 places), and then gradually add glue after the actual preparation. The electrode is reserved for subsequent glue application.

Solution-for-PEEK-over-molding-plastic-injection-molding-parts.jpg

Over 75,000 engineered plastic injection molding parts meterial are available for injection molding. The only thing we need from you is your material requirements, and we will work with our expert suppliers to get you the right material.