If the cooling system design of the mold is ineffective or the temperature of the medical plastic injection mold is not properly regulated, the plastic part will not be adequately cooled.As a result, the plastic part will warp and deform. The influence of medical plastic injection mold temperature on deformation can be seen to be very significant. Here are three suggestions for analyzing mold temperature:

DuPont Teflon (Teflon) trademark is mainly used in the following products: PTFE, FEP, PFA, ETFE, AF, NXT, FFR.Soluble polytetrafluoroethylene (PFA), the properties are similar to the name polytetrafluoroethylene (PTFE), and the can be produced by OEM PFA teflon plastic injection mold.

Plastic injection molding parts machining is a molding process in which heat-softened plastic material is shot from a barrel into a cavity to form the product into the desired shape. The injection molding process refers to the process of making semi-finished parts of a certain shape by pressing, injecting, cooling, and removing molten raw materials.

The 100,000-level The ventilation ducts for Medical plastic injection mold Clean Room workshop has officially started operation in our company. Is there anything special about the 100,000-level The ventilation ducts for Medical plastic injection mold Clean Room?

Leaked or condensed water can cause great damage to high precision plastic injection mold rust and cavities. Sometimes it's really bad mold rust that costs thousands of dollars to repair, there's a lot of personal stress in dealing with downtime and trying to make quality parts. If water or condensate stays long enough, it can cause serious damage

Plastic components are used in a variety of industries, and manufacturing these components by injection molding has come a long way. Generally speaking, there is a choice between traditional cold runners or more advanced hot runners. Each option has its own unique advantages and disadvantages, so understanding these differences and how they relate to your application can have a major impact on your productivity and overall profitability.

High precision connector injection mold cleaning is a key process in mold maintenance, and it is also a bottleneck restricting mold maintenance. Because the speed of mold manufacturing and development is much faster than the speed of mold cleaning, and the mold is ready for the next production immediately after the rapid cleaning, so the time left for mold cleaning is quite limited.

In today's era of rapid industrialization, plastic molds have become an indispensable part of the industrial era. Medical plastic injection mold manufacturer will tell you about the surface treatments commonly used in injection molds.1. Medical plastic injection mold Surface treatment polishing (polish)

There are two main functions of the high precision plastic injection mold Air vent:One is to remove the air in the mold cavity when the molten material is injected;The second is to eliminate various gases generated during the heating process of the material.

The Medical plastic injection mold design principle of the position of the ejector pin First, it should be designed in the place with the largest wrapping force on the mold; secondly, in the place with high adhesion force such as deep pits on the product; the ejector pin can also be placed in the place where poor exhaust is easy to occur.

Design standard Custom Medical plastic injection mold material selection principles:The first point: the selection of materials must meet its use function in the mold;

​The basic situation of the PA6-GF15 plastic injection molding parts information is as follows:Customer :TE